Unconfigure Transceiver-Test Failure-Action - Extreme Networks ExtremeWare Command Reference Manual

Commands for Status Monitoring and Statistics

unconfigure transceiver-test failure-action

unconfigure transceiver-test failure-action
Description
Returns the switch to its default of sending transceiver test messages to the syslog if too many failures
are detected within the specified window.
NOTE
This command is available only on modular switches.
Syntax Description
The command has no arguments or variables.
Default
N/A
Usage Guidelines
By default, the switch checks for errors within the last eight 20-second windows and sends messages to
the syslog.
To configure the number of windows the switch waits to check for errors, use the
configure
command. To modify how the switch responds if too many failures are
transceiver-test window
detected, use the command.
configure transceiver-test failure-action
Example
The following command returns the switch to its default of sending error messages to the syslog:
unconfigure transceiver-test failure-action
History
This command was first available in ExtremeWare 6.2.2b108.
This command was not supported in ExtremeWare 7.0.
This command is supported in ExtremeWare 7.1.0.
Platform Availability
This command is available only on modular switches.
820 ExtremeWare 7.5 Command Reference Guide