Fujitsu MB90460 Series Hardware Manual page 329

CHAPTER 14 MULTI-FUNCTIONAL TIMER
Table 14.4-7 PPG output control/input capture control status register (PICSH01)
Bit name
PGEN5 to
bit15
PGEN0:
to
PPG output
bit10
enable bits
IEI1:
bit9 Valid edge
indication bit
IEI0:
bit8 Valid edge
indication bit
310
• This bit is used to select PPG0 output to RTO0 to RTO5.
• This bit is an valid edge indication bit for capture register 1, to indicate a rising or
falling edge is detected.
• "0" is written to this bit when falling edge is detected.
• "1" is written to this bit when rising edge is detected.
• This bit is read-only.
(Note)
The read value is meaningless when EG11, EG10 = 00
• This bit is an value edge indication bit for capture register 0, to indicate a rising or
falling edge is detected.
• "0" is written to this bit when falling edge is detected.
• "1" is written to this bit when rising edge is detected.
• This bit is read-only.
(Note)
The read value is meaningless when EG01, EG00 = 00
Function
.
B
.
B