Table of Contents
Advertisement
CHAPTER 9 I/O PORT
●
Port operation after a reset
• When the CPU is reset, the DDR6 register is initialized to "0". As a result, the output buffer is turned
off (I/O mode changes to input), and the pins are placed in a high impedance state.
• The PDR6 register is not initialized when the CPU is reset. To use the port in output mode, therefore,
output mode must be specified in the DDR6 register after output data is set in the PDR6 register.
●
Port operation in stop or time-base timer mode
If the pin state specification bit (SPL) in the low-power consumption mode control register (LPMCR) is
already "1" when the port is shifted to stop or time-base timer mode, the port pins are placed in a high-
impedance state. This is because the output buffer is turned off forcibly regardless of the value in the
DDR6 register. Note that the inputs are fixed at a certain level to prevent leakage due to an open circuit.
Table 9.9-4 lists the states of the port 6 pins.
Table 9.9-4 States of Port 6 Pins
Pin
Normal operation
P60/SIN1 to
General-purpose I/O port General-purpose I/O port General-purpose I/O port
P63/INT7
SPL : Pin state specification bit of low-power consumption mode control register (LPMCR)
Hi-Z: High impedance
202
Stop mode or time-base
Sleep mode
Stop mode or time-base
timer mode
(SPL = 0)
Input shut down/output in
Hi-Z
timer mode
(SPL = 1)
Advertisement
Table of Contents
