Siemens RUGGEDCOM ROX II User Manual page 97

RUGGEDCOM ROX II
CLI User Guide
Getting Started
This section describes startup tasks to be performed during the initial commissioning of the device. Tasks include
connecting to the device and accessing the RUGGEDCOM ROX II CLI, as well as configuring a basic network.
CONTENTS
• Section 3.1, "Connecting to RUGGEDCOM ROX II"
• Section 3.2, "Configuring a Basic Network"
Section 3.1
Connecting to RUGGEDCOM ROX II
The Web user interface and Command Line Interface (CLI) can be accessed via a direct connection between a
workstation and a device or a remote connection over the network.
CONTENTS
• Section 3.1.1, "Default IP Address"
• Section 3.1.2, "Connecting Directly"
• Section 3.1.3, "Connecting Remotely"
Section 3.1.1
Default IP Address
The default IP address for the device is as follows:
Port
MGMT
All other Ethernet ports
Section 3.1.2
Connecting Directly
The Command Line Interface (CLI) can be accessed directly using an appropriate cable connection between the
device and a workstation.
To access the Command Line Interface (CLI) using a direct connection to the device, do the following:
Connecting to RUGGEDCOM ROX II
IP Address/Mask
192.168.1.2/24
192.168.0.2/24
Chapter 3
Getting Started
51