Siemens RUGGEDCOM ROX II User Manual page 412

Chapter 12
Tunneling and VPNs
Parameter
dstmac { dstmac }
proto { proto }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
6. Add the rule to a virtual switch filter. For more information, refer to
Virtual Switch Filter".
Section 12.1.6.4
Adding a Rule to a Virtual Switch Filter
To add a rule to a virtual switch filter, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the rule by typing:
security virtualswitch-filter virtualswitch name rule rule
Where:
• name is the name of the virtual switch filter
• rule is the name of the rule
3. Configure the in/out interfaces for the rule. For more information, refer to
Interface".
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 12.1.6.5
Deleting a Rule
To delete a rule used to filter virtual switch traffic, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the rule by typing:
no security virtualswitch-filter rules rule
Where:
• rule is the name of the rule
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 12.1.6.6
Deleting a Rule from a Virtual Switch Filter
To delete a rule from a virtual switch filter, do the following:
366
Synopsis: A string 17 characters long
The required destination MAC address for incoming frames.
Synopsis: { iso, arp, ipv4, ipv6 } or a string
The pre-defined protocol or hex-string (i.e. 0x88A2) used to create the frames.
This parameter is mandatory.
Description
Section 12.1.6.4, "Adding a Rule to a
Section 12.1.7.2, "Adding an In/Out
Adding a Rule to a Virtual Switch Filter
RUGGEDCOM ROX II
CLI User Guide