Siemens RUGGEDCOM ROX II User Manual page 502

Chapter 13
Unicast and Multicast Routing
NOTE
For information about configuring the lifetime of an LSP, refer to
Lifetime of
CONTENTS
• Section 13.6.10.1, "Viewing a List of LSP Refresh Intervals"
• Section 13.6.10.2, "Adding an LSP Refresh Interval"
• Section 13.6.10.3, "Deleting an LSP Refresh Interval"
Section 13.6.10.1
Viewing a List of LSP Refresh Intervals
To view a list of LSP refresh intervals configured for an IS-IS area, type:
show running-config routing isis area name lsp-refresh-interval
Where:
• name is the unique name for a routing process that belongs to a specific router.
If intervals have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing isis area Area_1 lsp-refresh-interval | tab
ISTYPE INTERVAL
------------------------
level-1-only 60
!
!
If no intervals have been configured, add intervals as needed. For more information, refer to
"Adding an LSP Refresh
Section 13.6.10.2
Adding an LSP Refresh Interval
To add an LSP refresh interval to an IS-IS area, do the following:
IMPORTANT!
The LSP refresh interval must be 300 seconds less than the LSP lifetime interval. For more information
about LSP refresh intervals, refer to
1. Make sure the CLI is in Configuration mode.
2. Add a new interval by typing:
routing isis area name lsp-refresh-interval is-type [ level-1-2 | level-1-only | level-2-only ]
interval seconds
Where:
• name is the unique name for a routing process that belongs to a specific router.
• level is the IS type.
456
LSPs".
Interval".
Section 13.6.9, "Managing the Lifetime of
Section 13.6.9, "Managing the
Section 13.6.10.2,
LSPs".
Viewing a List of LSP Refresh Intervals
RUGGEDCOM ROX II
CLI User Guide