RUGGEDCOM ROX II
CLI User Guide
Device Management
This chapter describes how to manage device hardware, including ports, files, logs, firmware, etc.
CONTENTS
•
Section 4.1, "Displaying Device and Software Information"
•
Section 4.2, "Viewing Chassis Information and Status"
•
Section 4.3, "Viewing the Parts List"
•
Section 4.4, "Shutting Down the Device"
•
Section 4.5, "Rebooting the Device"
•
Section 4.6, "Restoring Factory Defaults"
•
Section 4.7, "Decommissioning the Device"
•
Section 4.8, "Managing Feature Keys"
•
Section 4.9, "Managing Files"
•
Section 4.10, "Managing Logs"
•
Section 4.11, "Managing the Software Configuration"
•
Section 4.12, "Upgrading/Downgrading the RUGGEDCOM ROX II Software"
•
Section 4.13, "Monitoring Firmware Integrity"
•
Section 4.14, "Managing the Fan Controller"
•
Section 4.15, "Managing Fixed Modules"
•
Section 4.16, "Managing Line Modules"
•
Section 4.17, "Managing SFP Transceivers (RUGGEDCOM RX5000 Only)"
•
Section 4.18, "Managing Routable Ethernet Ports"
Section 4.1
Displaying Device and Software Information
During troubleshooting or when ordering new devices/features, Siemens may request specific information about
the device, such as the model, order code or system serial number.
To display general information about the device and its software, type:
show chassis chassis-status
A table or list similar to the following example appears:
ruggedcom# show chassis chassis-status
chassis-status
Displaying Device and Software Information
Chapter 4
Device Management
55