Siemens RUGGEDCOM ROX II User Manual page 325

RUGGEDCOM ROX II
CLI User Guide
This list provides the following information:
Parameter
running
good
open
short
imped
pass-fail-total
run-count
pass-count
fail-count
Section 8.1.8.3
Clearing Cable Diagnostic Statistics
The following describes how to clear the statistics collected when cable diagnostic tests are performed. All of the
statistics or only those for a specific switchport can be cleared.
Clearing Cable Diagnostic Statistics
Synopsis: { true, false }
Whether or not a cable test is currently running on this port
This parameter is mandatory.
Synopsis: A 16-bit unsigned integer
The number of times GOOD TERMINATION (no fault) is detected on the cable pairs of the
selected port.
This parameter is mandatory.
Synopsis: A 16-bit unsigned integer
The number of times OPEN is detected on the cable pairs of the selected port.
This parameter is mandatory.
Synopsis: A 16-bit unsigned integer
The number of times SHORT is detected on the cable pairs of the selected port.
This parameter is mandatory.
Synopsis: A 16-bit unsigned integer
The number of times IMPEDANCE MISMATCH is detected on the cable pairs of the selected
port.
This parameter is mandatory.
Synopsis: A string 1 to 19 characters long
This field summarizes the results of the cable diagnostics performed so far.
• Pass : the number of times cable diagnostics were successfully completed on the selected
port.
• Fail : the number of times cable diagnostics failed to complete on the selected port.
• Total : the total number of times cable diagnostics have been attempted on the selected
port.
This parameter is mandatory.
Synopsis: A 16-bit unsigned integer
Run Count : The total number of iterations
This parameter is mandatory.
Synopsis: A 16-bit unsigned integer
Pass Count
This parameter is mandatory.
Synopsis: A 16-bit unsigned integer
Failure Count
This parameter is mandatory.
Description
Chapter 8
Layer 2
279