Siemens RUGGEDCOM ROX II User Manual page 529

RUGGEDCOM ROX II
CLI User Guide
1. Make sure the CLI is in Configuration mode.
2. Add the new filter by typing:
routing bgp filter route-map tag
Where:
• tag is the tag for the route map filter
3. Add one or more entries. For more information, refer to
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 13.8.2.4
Adding a Route Map Filter Entry
To add an entry for an route map filter, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the new filter by typing:
routing bgp filter route-map tag entry number
Where:
• tag is the tag for the route map filter
• number is the sequence number for the entry
3. Configure the following parameter(s) as required:
Parameter
action { action }
call { call }
on-match-goto { on-match-goto }
4. Configure the match rules for the route map filter. For more information, refer to
"Configuring Match
5. Configure a set for the route map filter. For more information, refer to
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
6.
Section 13.8.2.5
Deleting a Route Map Filter
To delete a route map filter for dynamic BGP routes, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the filter key by typing:
Adding a Route Map Filter Entry
Synopsis: { deny, permit }
Default: permit
Action.
Synopsis: A string
Jump to another route-map after match+set.
Synopsis: A string
Go to this entry on match.
Rules".
Section 13.8.2.4, "Adding a Route Map Filter
Description
Section 13.8.2.8, "Configuring a
Chapter 13
Unicast and Multicast Routing
Entry".
Section 13.8.2.7,
Set".
483