Siemens RUGGEDCOM ROX II User Manual page 655

RUGGEDCOM ROX II
CLI User Guide
ruggedcom# show running-config services vrrp group
services
vrrp
group group1
!
!
!
If no VRRP groups have been configured, add groups as needed. For more information, refer to
"Adding a VRRP Group".
Section 14.1.5.2
Adding a VRRP Group
To add a VRRP group, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the group by typing:
services vrrp group name
Where:
• name is the name of the VRRP group
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 14.1.5.3
Deleting a VRRP Group
To delete a VRRP group, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the group by typing:
no services vrrp group name
Where:
• name is the name of the VRRP group
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 14.1.6
Managing VRRP Instances
VRRP instances define the interfaces monitored by VRRP. Two or more instances can be added to the same VRRP
group, which allows them to failover together.
CONTENTS
• Section 14.1.6.1, "Viewing a List of VRRP Instances"
• Section 14.1.6.2, "Adding a VRRP Instance"
Adding a VRRP Group
Chapter 14
Network Redundancy
Section 14.1.5.2,
609