Siemens RUGGEDCOM ROX II User Manual page 123

RUGGEDCOM ROX II
CLI User Guide
Disable
no admin logging diagnostics xpath-trace-log enabled
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 4.10.4.6
Enabling/Disabling the WebUI Trace Log
The WebUI trace log records all transactions related to the Web interface, such as configuration changes, error
messages, etc.
CAUTION!
Configuration hazard – risk of reduced performance. Enabling diagnostic logging will significantly
affect the performance of RUGGEDCOM ROX II. Only enable diagnostic logging when directed by
Siemens.
To enable or disable the WebUI Trace log, do the following:
1. Make sure the CLI is in Configuration mode.
2. Enable or disable the WebUI Trace log by typing the following commands:
Enable
admin logging diagnostics webui-trace-log enabled
Disable
no admin logging diagnostics webui-trace-log enabled
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 4.10.5
Managing Remote Syslog Servers
RUGGEDCOM ROX II can support up to 6 event message collectors, or remote Syslog servers. Remote Syslog
provides the ability to configure:
• IP address(es) of collector(s)
• Event filtering for each collector based on the event severity level
CONTENTS
• Section 4.10.5.1, "Viewing a List of Remote Servers"
• Section 4.10.5.2, "Adding a Remote Server"
• Section 4.10.5.3, "Deleting a Remote Server"
Section 4.10.5.1
Viewing a List of Remote Servers
To view a list of remote servers, type:
Enabling/Disabling the WebUI Trace Log
Chapter 4
Device Management
77