Siemens RUGGEDCOM ROX II User Manual page 592

Chapter 13
Unicast and Multicast Routing
Disable
no mpls interface-mpls interface enable
Where:
• interface is the name of the interface
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 13.10.5
Managing Static Label Binding
This section describes how to bind (or reserve) labels for IPv4 or network prefixes.
CONTENTS
• Section 13.10.5.1, "Viewing the Status of Static Label Binding"
• Section 13.10.5.2, "Viewing a List of Static Labels"
• Section 13.10.5.3, "Adding a Static Label"
• Section 13.10.5.4, "Deleting a Static Label"
Section 13.10.5.1
Viewing the Status of Static Label Binding
To view the status of all configured static label binding, type:
show mpls status static-binding
If static label binding has been configured, a table similar to the following example appears:
ruggedcom# show mpls status static-binding
IP ADDRESS
----------------------------------------------
192.168.20.0/24
192.168.200.0/24
This table provides the following information:
Parameter
ip-address
in-label
out-label
nexthop
546
IN OUT
LABEL LABEL NEXTHOP
90 101 192.168.10.2
95 100 192.168.10.2
Synopsis: A string
The destination address prefix.
Synopsis: A string
The incoming (local) label.
Synopsis: A string
The outgoing (remote) label.
Synopsis: A string
The destination next hop router.
Description
Managing Static Label Binding
RUGGEDCOM ROX II
CLI User Guide