Siemens RUGGEDCOM ROX II User Manual page 283

RUGGEDCOM ROX II
CLI User Guide
Parameter
Parameter
network-ip { network-ip }
shared-network { shared-network }
4. Configure the options for the subnet. For more information, refer to
Options".
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
Section 7.3.8.3
Configuring Subnet Options
To configure options for a subnet, do the following:
NOTE
Options set at the subnet level override options set at the DHCP server level.
1. Make sure the CLI is in Configuration mode.
2. Navigate to:
• For IPv4
services dhcpserver subnet-name name options
• For IPv6
services dhcpserver6 subnet6-name name options
Where:
• name is the name of the subnet
3. Configure the leased time settings by configuring the following parameter(s):
• For IPv4:
default { default }
maximum { maximum }
• For IPv6:
default { default }
Configuring Subnet Options
The shared-network that this host belongs to.
Synopsis: A string 4 to 43 characters long
The network IPv6 address for this subnet.
This parameter is mandatory.
Synopsis: A string
The shared-network that this host belongs to.
Parameter
Synopsis: A 32-bit unsigned integer
Default: 600
The minimum leased time in seconds that the server offers to the clients.
Synopsis: A 32-bit unsigned integer
Default: 7200
The maximum leased time in seconds that the server offers to the clients.
Parameter
Synopsis: A 32-bit unsigned integer
Default: 600
IP Address Assignment
Description
Description
Section 7.3.8.3, "Configuring Subnet
Description
Description
Chapter 7
237