Siemens RUGGEDCOM ROX II User Manual page 301

RUGGEDCOM ROX II
CLI User Guide
• prefix is the prefix
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 7.3.16
Managing Temporary Subnets
One or more optional IPv6 subnets with temporary addresses can be defined for the server to offer to the client.
CONTENTS
• Section 7.3.16.1, "Viewing a List of Temporary Subnets"
• Section 7.3.16.2, "Adding a Temporary Subnet"
• Section 7.3.16.3, "Deleting a Temporary Subnet"
Section 7.3.16.1
Viewing a List of Temporary Subnets
To view a list of temporary subnets, type:
For DHCP IPv6 subnets
show running-config services dhcpserver6 subnet6-name name options temporarysubnet6
Where:
• name is the name of the subnet
If temporary subnets have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config services dhcpserver6 subnet6-name sub2 options temporarysubnet6
services
dhcpserver6
subnet6-name sub2
options
temporarysubnet6 2001:db8:28d2::/112
!
!
!
!
!
!
If no prefixes have been configured, add ranges as needed. For more information, refer to
"Adding an IPv6 Prefix".
Section 7.3.16.2
Adding a Temporary Subnet
To add a temporary subnet, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the prefix by typing:
Managing Temporary Subnets
Chapter 7
IP Address Assignment
Section 7.3.15.2,
255