Siemens RUGGEDCOM ROX II User Manual page 473

RUGGEDCOM ROX II
CLI User Guide
• Section 12.9.2, "Viewing a List of 6in4 or 4in6 Tunnels"
• Section 12.9.3, "Viewing the Status of 6in4/4in6 Tunnels"
• Section 12.9.4, "Adding a 6in4 or 4in6 Tunnel"
• Section 12.9.5, "Deleting a 6in4 or 4in6 Tunnel"
Section 12.9.1
Enabling/Disabling 6in4 or 4in6 Tunnels
To enable or disable all 6in4 or 4in6 tunnels, do the following:
1. Make sure the CLI is in Configuration mode.
2. Enable or disable 6in4/4in6 tunnels by typing:
Enabling
tunnel [ ip6in4 | ip4in6 ] enabled
Disabling
no tunnel [ ip6in4 | ip4in6 ] enabled
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 12.9.2
Viewing a List of 6in4 or 4in6 Tunnels
To view a list of 6in4 or 4in6 tunnels configured on the device, type:
show running-config tunnel [ ip6in4 | ip4in6 ] tunnel
A table or list similar to the following example appears:
ruggedcom# show running-config tunnel ip6in4 tunnel | tab
NAME ENABLED
-------------------------------------------------------
ruggedcom true
!
Section 12.9.3
Viewing the Status of 6in4/4in6 Tunnels
To view the status of a 6in4 or 4in6 tunnel, type:
show interfaces [ ip6in4 | ip4in6 ] tunnel name
Where:
• name is the name of the tunnel
A table or list similar to the following example appears:
ruggedcom# show interfaces ip6in4 tunnel
Enabling/Disabling 6in4 or 4in6 Tunnels
LOCAL IP REMOTE IP
192.168.30.14 172.23.30.14
MTU
1480
Chapter 12
Tunneling and VPNs
427