Siemens RUGGEDCOM ROX II User Manual page 430

Chapter 12
Tunneling and VPNs
If no sessions have been configured, add sessions as needed. For more information, refer to
"Adding a Session".
Section 12.4.5.2
Adding a Session
To add a session to a static or dynamic L2TPv3 tunnel, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the session by typing:
tunnel l2tpv3 [ static | dynamic ] tunnel tunnel-name session tunnel-session
Where:
• tunnel-name is the name of the tunnel
• tunnel-session is the name of the tunnel session
3. Configure the following parameter(s) as required:
NOTE
The Log parameter is only applicable to dynamic L2TPv3 tunnel sessions.
Parameter
enabled
remote-end-id { remote-end-id }
l2tp-specific-sublayer { l2tp-specific-
sublayer }
mtu { mtu }
log
IMPORTANT!
Configuration of the local cookie should match the configuration of the remote cookie on the
device at the other end of the L2TPv3 tunnel.
Type local-cookie and then configure the following parameters as required:
4.
Parameter
size { size }
low-value { low-value }
384
Synopsis: { true, false }
Default: true
Enables/Disables the session
Synopsis: A 32-bit signed integer between 1 and 65535
Remote endpoint ID to identify session with remote system
This parameter is mandatory.
Synopsis: { default, none }
Default: default
L2TP specific sublayer processing type
Synopsis: A 32-bit signed integer between 68 and 9216
Default: 1460
MTU of network interface
Synopsis: { true, false }
Default: false
Enables/Disables logging session control messages
Synopsis: { 4, 8 }
Cookie size in byte.
Synopsis: A 32-bit unsigned integer
Section 12.4.5.2,
Description
Description
RUGGEDCOM ROX II
CLI User Guide
Adding a Session