Siemens RUGGEDCOM ROX II User Manual page 580

Chapter 13
Unicast and Multicast Routing
Parameter
prefix-list { prefix-list }
Parameter
prefix-list { prefix-list }
Parameter
ifname { ifname }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 13.9.7
Managing Incoming Route Filters
Incoming route advertisements can be filtered by assigning one or route map filters. This can be useful for
excluding specific OSPF routes from the routing table.
NOTE
For more information about route map filters, refer to
CONTENTS
• Section 13.9.7.1, "Viewing List of Incoming Route Filters"
• Section 13.9.7.2, "Adding an Incoming Route Filter"
• Section 13.9.7.3, "Deleting an Incoming Route Filter"
Section 13.9.7.1
Viewing List of Incoming Route Filters
To view a list of route filters configured for incoming advertised routes, type:
• For Standard OSPF Routes
show running-config routing ospf incoming-route-filter
• For VRF Routes via OSPF
show running-config routing ospf vrf vrf incoming-route-filter
Where:
• vrf is the name of the chosen VRF
If route filters have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing ospf incoming-route-filter
routing ospf
incoming-route-filter ospf_route_1
534
Synopsis: A string
The prefix list name.
Synopsis: A string
The prefix list name.
Synopsis: A string
The interface name.
Section 13.9.6, "Managing Route
Description
Description
Description
Managing Incoming Route Filters
RUGGEDCOM ROX II
CLI User Guide
Maps".