Siemens RUGGEDCOM ROX II User Manual page 379

RUGGEDCOM ROX II
CLI User Guide
If protocols have been configured, a table or list similar to the following example appears:
ruggedcom# show interfaces serial port protocol
IFNAME PROTOCOL
-------------------
ser-3-1 none
ser-3-2 none
ser-3-3 none
ser-3-4 none
ser-3-5 none
ser-3-6 none
If no serial port protocols have been configured, add protocols as needed. For more information, refer to
Section 10.2.3, "Adding a Serial Port
Section 10.2.3
Adding a Serial Port Protocol
To add a serial port protocol, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the protocol by typing:
interface serial slot port protocols protocol
Where:
• slot is the name of the module location.
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module.
• protocol is the protocol type. Options include dnp, tcpmodbus, rawsocket and vmserial.
3. If dnp, tcpmodbus, or rawsocket was selected, configure the protocol.
• For information about configuring a DNP protocol, refer to
• For information about configuring a Modbus TCP protocol, refer to
Modbus TCP
• For information about configuring a raw socket protocol, refer to
Socket Protocol".
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 10.2.4
Configuring the DNP Protocol
To configure the DNP protocol for a serial port, do the following:
1. Make sure the CLI is in Configuration mode.
Navigate to interface » serial » {interface} » protocols » dnp » setdnp, where {interface} is the serial port.
2.
3. Configure the following parameter(s) as required:
Parameter
address-learning { address-learning }
Adding a Serial Port Protocol
Protocol".
Protocol".
Synopsis: A string 1 to 15 characters long
The interface to learn the RTU address from.
Section 10.2.4, "Configuring the DNP
Section 10.2.5, "Configuring the
Section 10.2.6, "Configuring the Raw
Description
Chapter 10
Serial Server
Protocol".
333