Siemens RUGGEDCOM ROX II User Manual page 436

Chapter 12
Tunneling and VPNs
tunnel l2tunneld goose tunnel name
Where:
• name is the name of the GOOSE tunnel
3. Configure the following parameter(s) as required:
Parameter
interface { interface }
multicast-mac { multicast-mac }
4. If necessary, configure one or more remote daemons for the tunnel. For more information, refer to
Section 12.5.5.2, "Adding a Remote
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
Section 12.5.4
Deleting a GOOSE Tunnel
To delete a GOOSE tunnel, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the GOOSE tunnel by typing:
no tunnel l2tunneld goose tunnel name
Where:
• name is the name of the GOOSE tunnel
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 12.5.5
Managing Remote Daemons for GOOSE Tunnels
In place of a local Ethernet interface for the tunnel egress, IP addresses for a remote daemon can be specified.
Several endpoints may be added with these fields using successive edits of the tunnel configuration.
CONTENTS
• Section 12.5.5.1, "Viewing a List of Remote Daemons"
• Section 12.5.5.2, "Adding a Remote Daemon"
• Section 12.5.5.3, "Deleting a Remote Daemon"
390
Synopsis: A string
The interface to listen on for GOOSE frames.
Synopsis: A string 17 characters long
The multicast MAC address to listen for.
This parameter is mandatory.
Daemon".
Description
Deleting a GOOSE Tunnel
RUGGEDCOM ROX II
CLI User Guide