Siemens RUGGEDCOM ROX II User Manual page 552

Chapter 13
Unicast and Multicast Routing
Figure 28: Redundant Route Reflector Topology
1. Cluster 2. Route Reflector
Section 13.8.11.2
Configuring the Device as a Route Reflector
To configure the device to be a route reflector for a specific cluster, do the following:
1. Make sure the CLI is in Configuration mode.
2. Configure the device as a route reflector by typing:
routing bgp route-reflector enabled cluster-id id
Where id is the 4-byte ID of the cluster to which the device belongs (e.g. 1.2.3.4).
3. Configure one or more BGP neighbors to be clients of the device. For more information, refer to
Section 13.8.11.3, "Configuring BGP Neighbors as
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 13.8.11.3
Configuring BGP Neighbors as Clients
When the device is configured to be a route reflector, BGP neighbors can then be configured to be clients of the
reflector.
BGP Neighbors
To configure a BGP neighbor to be a client of the device, do the following:
1. Make sure a BGP neighbor is defined. For more information, refer to
2. Configure the desired BGP neighbor to be a client of the route reflector by typing:
routing bgp neighbor address route-reflector-client enabled
Where address is the IP address of the BGP neighbor.
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
506
1
RR1
Clients".
2
RR2
1
Section 13.8.6.2, "Adding a
Configuring the Device as a Route Reflector
RUGGEDCOM ROX II
CLI User Guide
Neighbor".