Siemens RUGGEDCOM ROX II User Manual page 578

Chapter 13
Unicast and Multicast Routing
Section 13.9.6.4
Adding a Route Map Filter Entry
To add an entry for an route map filter, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the new filter by typing:
• For Standard OSPF Routes
routing ospf filter route-map tag entry number
• For VRF Routes via OSPF
routing ospf vrf vrf filter route-map tag entry number
Where:
• vrf is the name of the chosen VRF
• tag is the tag for the route map filter
• number is the sequence number for the entry
3. Configure the following parameter(s) as required:
Parameter
action { action }
call { call }
on-match-goto { on-match-goto }
Parameter
metric { metric }
metric-type { metric-type }
4. Configure the match rules for the route map filter. For more information, refer to
"Configuring Match
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
Section 13.9.6.5
Deleting a Route Map Filter
To delete a route map filter for dynamic OSPF routes, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the filter key by typing:
• For Standard OSPF Routes
no routing ospf filter route-map tag
532
Synopsis: { deny, permit }
Default: permit
Action.
Synopsis: A string
Jump to another route-map after match+set.
Synopsis: A string
Go to this entry on match.
Synopsis: A 32-bit unsigned integer
Metric value.
Synopsis: An 8-bit signed integer between 1 and 2
External route type.
Rules".
Description
Description
Section 13.9.6.7,
Adding a Route Map Filter Entry
RUGGEDCOM ROX II
CLI User Guide