Siemens RUGGEDCOM ROX II User Manual page 169

RUGGEDCOM ROX II
CLI User Guide
Parameter
job-command { job-command }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 5.10.3
Deleting a Scheduled Job
To delete a scheduled Job, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the scheduled job by typing:
no admin scheduler schedule-jobs name
Where:
• name is the name of the scheduled job
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Deleting a Scheduled Job
For periodic jobs, sets the day of the week on which to run the scheduled job. Valid
entries are in the range of 0 to 6, where 0 represents Sunday, 1 represents Monday, and
so on. If no value is set, the job launches every day.
• To specify a single value, enter the value in the field. For example, to set the day to
Monday, enter 1.
• To specify a list of values, enter the values as a comma-separated list. For example, to
set the days to Friday, Saturday, and Sunday, enter 5,6,0.
• To specify a range of values, enter the range as comma-separated values. For example,
to set the days to Monday through Friday, enter 1-5.
This parameter is not required for configchange jobs.
Synopsis: A string 1 to 1024 characters long
One or more commands to execute at the scheduled time. For example, this command
saves the running configuration to a file name 'myconfig': show running-config | save
myconfig.
Do not use interactive commands or commands that require a manual response or
confirmation.
When entered in the CLI, the command string must be enclosed in quotation marks.
When entered in the WebUI, the command string must not be enclosed in quotation
marks.
This parameter is mandatory.
System Administration
Description
Chapter 5
123