Siemens RUGGEDCOM ROX II User Manual page 294

Chapter 7
IP Address Assignment
Section 7.3.12
Managing Address Pools (IPv6)
Address pools define a range of IP addresses that can be assigned to DHCP clients belonging to the same subnet.
CONTENTS
• Section 7.3.12.1, "Viewing a List of Address Pools (IPv6)"
• Section 7.3.12.2, "Adding an Address Pool (IPv6)"
• Section 7.3.12.3, "Deleting an Address Pool (IPv6)"
Section 7.3.12.1
Viewing a List of Address Pools (IPv6)
To view a list of address pools configured for a DHCP subnet, type:
show running-config services dhcpserver6 subnet6-name name options ippool6
Where:
• name is the name of the subnet
If pools have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config services dhcpserver6 subnet6-name options ippool6
services
dhcpserver6
subnet6-name Sub
options
ippool6 Pool1
iprange6 2001:db8:2728::2221
end 2001:db8:2728::2230
!
!
!
!
!
!
!
If no IP pools have been configured, add pools as needed. For more information, refer to
an Address Pool (IPv6)".
Section 7.3.12.2
Adding an Address Pool (IPv6)
To add an address pool to a DHCP subnet, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the address pool by typing:
services dhcpserver6 subnet6-name name options ippool6 ippoolname
Where:
• name is the name of the subnet
248
RUGGEDCOM ROX II
CLI User Guide
Section 7.3.12.2, "Adding
Managing Address Pools (IPv6)