Siemens RUGGEDCOM ROX II User Manual page 519

RUGGEDCOM ROX II
CLI User Guide
3. Configure the following parameter(s) as required:
Parameter
prefix-list { prefix-list }
4. If necessary, configure an event tracker to track network commands. For more information, refer to
Section 13.7.4.2, "Tracking
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
Section 13.7.8.3
Deleting a Prefix List Distribution Path
To delete a prefix list distribution path for dynamic RIP routes, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the path by typing:
no routing rip distribute-prefix-list direction interface
Where:
• direction is the direction (incoming or outgoing) in which to filter routing updates.
• interface is the name of the interface. This parameter is optional.
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 13.7.9
Managing Key Chains and Keys
Key chains are collections of keys (or shared secrets), which are used to authenticate communications over a
dynamic RIP network. Only routers with the same key are able to send and receive advertisements.
Multiple key chains can be configured for different groups of interfaces and the lifetime for each key within a
chain can be separately configured.
CONTENTS
• Section 13.7.9.1, "Viewing a List of Key Chains"
• Section 13.7.9.2, "Viewing a List of Keys"
• Section 13.7.9.3, "Adding a Key Chain"
• Section 13.7.9.4, "Adding a Key"
• Section 13.7.9.5, "Deleting a Key Chain"
• Section 13.7.9.6, "Deleting a Key"
Deleting a Prefix List Distribution Path
Synopsis: A string
The name of the prefix list.
This parameter is mandatory.
Commands".
Unicast and Multicast Routing
Description
Chapter 13
473