Siemens RUGGEDCOM ROX II User Manual page 544

Chapter 13
Unicast and Multicast Routing
Section 13.8.7.2
Adding a Network
To add a network for the BGP protocol, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the network by typing:
routing bgp network address
Where:
• address is the IP subnet address and prefix for the network
3. If necessary, configure an event tracker to track network commands. For more information, refer to
Section 13.8.7.3, "Tracking Commands for a BGP
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 13.8.7.3
Tracking Commands for a BGP Network
Network commands can be tracked using event trackers configured under global » tracking. For more
information about event trackers, refer to
The network command is activated based on the event tracker's state. The apply-when parameter determines
when the command is activated. For example, if the apply-when parameter is set to down, the network
command becomes active (thereby advertising the network to a router's BGP peers) when the tracked target is
unavailable.
To track a command for a BGP network, do the following:
1. Make sure the CLI is in Configuration mode.
2. Navigate to routing » bgp » network » {address} » track, where {address} is the IP subnet address and prefix
for the network.
3. Configure the following parameter(s) as required:
Parameter
event { event }
apply-when { apply-when }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 13.8.7.4
Deleting a Network
To delete a network configured for the BGP protocol, do the following:
1. Make sure the CLI is in Configuration mode.
498
Network".
Section 13.5, "Managing Event
Synopsis: A string
Select an event.
This parameter is mandatory.
Synopsis: { up, down }
Default: up
Advertises the network when the tracked event state goes UP or stops advertising the
network when the tracked event goes DOWN.
Trackers".
Description
RUGGEDCOM ROX II
CLI User Guide
Adding a Network