Siemens RUGGEDCOM ROX II User Manual page 612

Chapter 13
Unicast and Multicast Routing
Parameter
route-map { route-map }
external { external }
inter-area { inter-area }
intra-area { intra-area }
3. Configure prefix list filters for the VRF instance. For more information, refer to
Prefix List".
4. Configure areas for the VRF instance. For more information, refer to
5. Configure route map filters for the VRF instance. For more information, refer to
Route Map Filter".
6. Configure redistribution metrics for the VRF instance. For more information, refer to
"Adding a Redistribution
7. Configure interfaces for the VRF instance. For more information, refer to
Routing Interface".
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
8.
Section 13.11.7.3
Deleting a VRF Instance
To delete a VRF instance under OSPF, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the definition key by typing:
no routing ospf vrf name
Where:
• name is the name of the VRF instance
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 13.11.8
Managing IP/VPN Tunnels
IP/VPN tunnels use the VPNv4 protocol to exchange customer prefixes (i.e. route distributions and route targets)
and labels between Provider Edge (PE) routers. IP/VPNs provide isolation of the interfaces connecting each end of
the VPN.
566
The metric type for default route.
Synopsis: A string
The route map name.
Synopsis: A 32-bit unsigned integer between 1 and 255
The administrative distance for external routes.
Synopsis: A 32-bit unsigned integer between 1 and 255
The administrative distance for inter-area routes.
Synopsis: A 32-bit unsigned integer between 1 and 255
The administrative distance for intra-area routes.
Metric".
Description
Section 13.9.4.3, "Adding a
Section 13.9.5.2, "Adding an
Section 13.9.6.3, "Adding a
Section 13.9.8.2,
Section 13.9.9.2, "Configuring a
Deleting a VRF Instance
RUGGEDCOM ROX II
CLI User Guide
Area".