Siemens RUGGEDCOM ROX II User Manual page 620

Chapter 13
Unicast and Multicast Routing
Parameter
send-community { send-community }
remote-as { remote-as }
ebgp-multihop { ebgp-multihop }
maximum-prefix { maximum-prefix }
next-hop-self
password { password }
update-source { update-source }
disable-connected-check
soft-reconfiguration
weight { weight }
4. Configure the route map settings by configuring the following parameter(s):
Parameter
in { in }
out { out }
5. Configure the prefix list distribution. For more information, refer to
Distribution of Prefix
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
6.
Section 13.11.12.3
Configuring the Distribution of Prefix Lists
To configure the distribution of prefix lists for a neighbor in an IPv4 address family, do the following:
1. Make sure the CLI is in Configuration mode.
2. Apply the desired prefix list the chosen route direction (incoming or outbound) by typing:
routing bgp address-family ipv4 vrf vrf neighbor address distribute-prefix-list [ in | out ]
prefix-list prefix
574
Synopsis: { standard, extended, both, none }
Default: both
Identifies the send Community. Default is both.
Synopsis: A 32-bit unsigned integer between 1 and 65535
A BGP neighbor.
This parameter is mandatory.
Synopsis: An 8-bit unsigned integer between 1 and 255
The maximum hop count. This allows EBGP neighbors not on directly connected
networks.
Synopsis: A 32-bit unsigned integer between 1 and 4294967295
The maximum prefix number accepted from this peer.
Disables the next hop calculation for this neighbor.
Synopsis: A string 1 to 1024 characters long
Password.
Synopsis: A string 7 to 15 characters long
Source IP address of routing updates.
Disables connection verification when establishing an eBGP peering session with a
single-hop peer that uses a loopback interface.
Per neighbor soft reconfiguration.
Synopsis: A 16-bit unsigned integer
The default weight for routes from this neighbor.
Synopsis: A string
Apply route map to incoming routes.
Synopsis: A string
Apply route map to outbound routes.
Lists".
Description
Description
Section 13.11.12.3, "Configuring the
Configuring the Distribution of Prefix Lists
RUGGEDCOM ROX II
CLI User Guide