Siemens RUGGEDCOM ROX II User Manual page 485

RUGGEDCOM ROX II
CLI User Guide
NOTE
Trackers only use ICMP messages to ping an IP target. Therefore, it can only provide availability for an
IP device, and only up to the IP layer.
CONTENTS
• Section 13.5.1, "Viewing a List of Event Trackers"
• Section 13.5.2, "Viewing Event Tracker Statistics"
• Section 13.5.3, "Adding an Event Tracker"
• Section 13.5.4, "Deleting an Event Tracker"
Section 13.5.1
Viewing a List of Event Trackers
To view a list of event trackers, type:
show running-config global tracking
If event trackers have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config global tracking
global
tracking
event host-in-lan-11
target 192.168.11.100
timeout 500
interval 500
fall 3
rise 3
!
!
!
If no event trackers have been configured, add event trackers as needed. For more information, refer to
Section 13.5.3, "Adding an Event
Section 13.5.2
Viewing Event Tracker Statistics
RUGGEDCOM ROX II records statistics for each event tracker.
To view the statistics for an event tracker, type:
show global tracking event statistics
A list similar to the following example appears:
ruggedcom# show global tracking event statistics
ECHO
NAME ATTEMPTS
-----------------------------------------------------------------
host-in-lan-11 0
Viewing a List of Event Trackers
Tracker".
ECHO MIN AVERAGE
REPLIES RTT RTT
0 0.0 0.0
STANDARD
MAX DEVIATION
RTT RTT
0.0 0.0
Chapter 13
Unicast and Multicast Routing
439