Siemens RUGGEDCOM ROX II User Manual page 239

RUGGEDCOM ROX II
CLI User Guide
Section 6.9.10
Managing Interfaces
Firewall interfaces are the LAN and WAN interfaces available to the router. Each interface must be placed in
a network zone. If an interface supports more than one zone, its zone must be marked as undefined and the
interface must use the zone host's setup to define a zone for each subnet on the interface.
Table: Example
Interface
Switch.0001
Switch.0002
Switch.0003
Switch.0004
W1ppp
CONTENTS
• Section 6.9.10.1, "Viewing a List of Interfaces"
• Section 6.9.10.2, "Adding an Interface"
• Section 6.9.10.3, "Associating an Interface with a Zone"
• Section 6.9.10.4, "Configuring a Broadcast Address"
• Section 6.9.10.5, "Deleting an Interface"
Section 6.9.10.1
Viewing a List of Interfaces
To view a list of interfaces, type:
show running-config security firewall fwconfig firewall fwinterface
Where firewall is the name of the firewall.
If interfaces have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config security firewall fwconfig fwinterface
security
firewall
fwconfig firewall
fwinterface fe-cm-1
zone man
description Interface
!
!
!
!
If no interfaces have been configured, add interfaces as needed. For more information, refer to
"Adding an Interface".
Managing Interfaces
Zone
Loc
Loc
Any
DMZ
net
Chapter 6
Security
Section 6.9.10.2,
193