Siemens RUGGEDCOM ROX II User Manual page 491

RUGGEDCOM ROX II
CLI User Guide
Parameter
System ID
Interface
L
State
Holdtime
SNPA
Section 13.6.4
Viewing the Status of the Link-State Database
To view the basic status of the link-state database for the IS-IS network, do the following:
1. Make sure IS-IS is configured. For more information, refer to
2. Display the basic status by typing:
routing status isis isis-database-status
Or display a more detailed status by typing:
routing status isis isis-database-detail-status
If IS-IS routes have been configured, a list similar to the following example appears:
ruggedcom# routing status isis isis-database-status
isis-database-status
Area area1:
IS-IS Level-1 link-state database:
LSP ID
R1.00-00
1 LSPs
IS-IS Level-2 link-state database:
LSP ID
Spirent-.00-00
R1.00-00
Spirent-right.00-00
Spirent-right.00-01
Spirent-right.00-00
Spirent-right.00-01
Spirent-right.00-00
Viewing the Status of the Link-State Database
The system ID.
The name of the interface.
The level. Possible levels are 1, 2 and 3, where 3 represents levels 1 and 2.
Adjacency state.
The remaining hold time in seconds.
The MAC address of the Sub-Network Point of Attachment (SNPA).
PduLen SeqNumber
* 75 0x00000015
PduLen SeqNumber
121 0x0000000f
* 75 0x00000015
1465 0x0000000f
295 0x0000000f
1465 0x0000000f
287 0x0000000f
1462 0x0000000f
Description
Section 13.6.2, "Configuring
Chksum Holdtime ATT/P/OL
0xe43a 1129 0/0/0
Chksum Holdtime ATT/P/OL
0xd5e6 871 0/0/0
0xe636 1031 0/0/0
0x3d65 871 0/0/0
0x6a0d 872 0/0/0
0x4638 872 0/0/0
0x54d0 872 0/0/0
0x6528 872 0/0/0
Chapter 13
Unicast and Multicast Routing
IS-IS".
445