Siemens RUGGEDCOM ROX II User Manual page 577

RUGGEDCOM ROX II
CLI User Guide
Section 13.9.6.2
Viewing a List of Route Map Filter Entries
To view a list of entries for a route map filter for either OSPF, type:
• For Standard OSPF Routes
show running-config routing ospf filter route-map tag entry
• For VRF Routes via OSPF
show running-config routing ospf vrf vrf filter route-map tag entry
Where:
• vrf is the name of the chosen VRF
• tag is the tag for the route map filter
If entries have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing ospf filter route-map map entry | tab
NEXT
SEQ ACTION CALL
OPERATION VALUE
---------------------------------------------------------------------------------------------
10 permit -
- -
!
!
If no filters have been configured, add filters as needed. For more information, refer to
Route Map Filter Entry".
Section 13.9.6.3
Adding a Route Map Filter
To add a route map filter for dynamic OSPF routes, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the new filter by typing:
• For Standard OSPF Routes
routing ospf filter route-map tag
• For VRF Routes via OSPF
routing ospf vrf vrf filter route-map tag
Where:
• vrf is the name of the chosen VRF
• tag is the tag for the route map filter
3. Add one or more entries. For more information, refer to
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Viewing a List of Route Map Filter Entries
ON
MATCH AS PREFIX PREFIX
ORIGINATOR
GOTO PATH LIST LIST
HOP ORIGIN ID
- - - -
- - -
PREFIX
LIST METRIC PEER
WEIGHT AS
- - -
Section 13.9.6.4, "Adding a Route Map Filter
Unicast and Multicast Routing
LOCAL
ORIGIN AS IP PREFERENCE
- - - -
Section 13.9.6.4, "Adding a
Chapter 13
-
Entry".
531