Siemens RUGGEDCOM ROX II User Manual page 456

Chapter 12
Tunneling and VPNs
• Section 12.8.5.3, "Deleting a Pre-Shared Key"
Section 12.8.5.1
Viewing a List of Pre-Shared Keys
To view a list of pre-shared keys, type:
show running-config tunnel ipsec preshared-key
If pre-shared keys have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config tunnel ipsec preshared-key
tunnel
ipsec
preshared-key 192.168.12.1 192.168.12.2
key $4$9YslfOBfkyYV8c1tqN4IDw==
!
!
!
If no pre-shared keys have been configured, add pre-shared keys as needed. For more information, refer to
Section 12.8.5.2, "Adding a Pre-Shared
Section 12.8.5.2
Adding a Pre-Shared Key
To add a pre-shared key, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the pre-shared key by typing:
tunnel ipsec preshared-key [ remote-address | local-address ] key key
Where:
• remote-address is the remote IP address
• local-address is the local IP address
• key is the is the content of the pre-shared key
3. Configure the following parameter(s) as required:
Parameter
key { key }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 12.8.5.3
Deleting a Pre-Shared Key
To delete a pre-shared key, do the following:
410
Key".
Synopsis: A string 1 to 8192 characters long
The pre-shared key.
This parameter is mandatory.
Description
Viewing a List of Pre-Shared Keys
RUGGEDCOM ROX II
CLI User Guide