Siemens RUGGEDCOM ROX II User Manual page 740

Chapter 16
Traffic Control and Classification
Where:
• interface is the name of the traffic control interface
3. Configure the following parameter(s) as required:
Parameter
iptype { iptype }
type { type }
inbandwidth { inbandwidth }
in-unit { in-unit }
outbandwidth { outbandwidth }
out-unit { out-unit }
description { description }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 16.2.2.3
Deleting a Traffic Control Interface
To delete a traffic control interface, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the traffic control interface by typing:
no qos traffic-control basic-configuration tcinterfaces interface
Where:
• interface is the name of the traffic control interface
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
694
Synopsis: { ipv4, ipv6, ipv4ipv6 }
Default: ipv4
Internet protocol type - use both when no addresses are used, otherwise define IPv4 and
IPv6 rules for each type of addresses used.
Synopsis: { internal, external, none }
Default: none
(optional) 'external' (facing toward the Internet) or 'internal' (facing toward a local
network). 'external' causes the traffic generated by each unique source IP address to be
treated as a single flow. 'internal' causes the traffic generated by each unique destination
IP address to be treated as a single flow. Internal interfaces seldom benefit from simple
traffic shaping.
Synopsis: A 16-bit unsigned integer
(optional) The incoming bandwidth of this interface. If incoming traffic exceeds the
given rate, received packets are dropped randomly. When unspecified, maximum speed
is assumed. Specify only the number here. The unit (kilobits, megabits) is specified in the
in-unit.
Synopsis: { none, kilobits, megabits }
Default: none
The unit for inbandwidth, per second.
Synopsis: A 16-bit unsigned integer
The outgoing bandwidth for this interface. Specify only the number here. The unit
(kilobits, megabits) is specified in the out-unit.
This parameter is mandatory.
Synopsis: { kilobits, megabits }
Default: megabits
The unit for outgoing bandwidth, per second.
Synopsis: A string
A description for this configuration item.
Description
Deleting a Traffic Control Interface
RUGGEDCOM ROX II
CLI User Guide