Siemens RUGGEDCOM ROX II User Manual page 498

Chapter 13
Unicast and Multicast Routing
Section 13.6.7.2
Adding an LSP Generation Interval
To add an LSP generation interval to an IS-IS area, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add a new interval by typing:
routing isis area name lsp-gen-interval is-type [ level-1-2 | level-1-only | level-2-only ]
interval seconds
Where:
• name is the unique name for a routing process that belongs to a specific router.
• level is the IS type.
• seconds is the minimum interval in seconds, ranging from 1 to 120. The default value is 30.
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 13.6.7.3
Deleting an LSP Generation Interval
To delete an LSP generation interval for an IS-IS area, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the LDP interface by typing:
no routing isis area name lsp-gen-interval is-type [ level-1-2 | level-1-only | level-2-only ]
interval seconds
Where:
• name is the unique name for a routing process that belongs to a specific router.
• level is the IS type.
• seconds is the minimum interval in seconds, ranging from 1 to 120. The default value is 30.
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 13.6.8
Managing SPF Calculations
IS-IS uses the Shortest Path First (SPF) algorithm to determine the best routes to every known destination in the
network. When the network topology (not external links) changes, a partial recalculation is required.
IS-IS can be configured to perform the SPF calculation every 1 to 120 seconds. By default, IS-IS performs the SPF
calculation every second. which could potentially be processor intensive, depending on the size of the area and
how often the topology changes.
CONTENTS
• Section 13.6.8.1, "Viewing a List of SPF Calculation Intervals"
• Section 13.6.8.2, "Adding an SPF Calculation Interval"
• Section 13.6.8.3, "Deleting an SPF Calculation Interval"
452
RUGGEDCOM ROX II
CLI User Guide
Adding an LSP Generation Interval