Siemens RUGGEDCOM ROX II User Manual page 468

Chapter 12
Tunneling and VPNs
tunnel ipsec connection name [ right | left ] subnet address
Where:
• name is the name of the connection
• address is the IP address and prefix of the private subnet
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 12.8.10.4
Deleting an Address for a Private Subnet
To delete an IP address for a private subnet, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the IP address by typing:
no tunnel ipsec connection name [ right | left ] subnet address
Where:
• name is the name of the connection
• address is the IP address and prefix of the private subnet
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 12.8.11
Example: Configuring an Encrypted VPN Tunnel
This example describes how to configure an encrypted VPN tunnel over a public network using Layer 3
RUGGEDCOM ROX II devices.
IMPORTANT!
The values shown are specific to the provided topology. Actual values can vary based on the user's
configuration.
422
CLI User Guide
Deleting an Address for a Private Subnet
RUGGEDCOM ROX II