Siemens RUGGEDCOM ROX II User Manual page 582

Chapter 13
Unicast and Multicast Routing
Section 13.9.8
Managing Redistribution Metrics
Redistribution metrics redistribute routing information from other routing protocols, static routes or routes
handled by the kernel. Routes for subnets that are directly connected to the router, but not part of the OSPF areas,
can also be advertised.
CONTENTS
• Section 13.9.8.1, "Viewing a List of Redistribution Metrics"
• Section 13.9.8.2, "Adding a Redistribution Metric"
• Section 13.9.8.3, "Deleting a Redistribution Metric"
Section 13.9.8.1
Viewing a List of Redistribution Metrics
To view a list of redistribution metrics for dynamic OSPF routes, type:
• For Standard OSPF Routes
routing ospf redistribute
• For VRF Routes via OSPF
routing ospf vrf vrf redistribute
Where:
• vrf is the name of the chosen VRF
If metrics have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing ospf redistribute
routing ospf
redistribute bgp
no metric-type
no metric
!
!
If no redistribution metrics have been configured, add metrics as needed. For more information, refer to
Section 13.9.8.2, "Adding a Redistribution
Section 13.9.8.2
Adding a Redistribution Metric
To add a redistribution metric for dynamic OSPF routes, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the metric by typing:
• For Standard OSPF Routes
routing ospf redistribute [ bgp | rip | connected | static | kernel ]
• For VRF Routes via OSPF
routing ospf vrf vrf redistribute [ bgp | rip | connected | static | kernel ]
536
Metric".
RUGGEDCOM ROX II
CLI User Guide
Managing Redistribution Metrics