Siemens RUGGEDCOM ROX II User Manual page 560

Chapter 13
Unicast and Multicast Routing
Enable the router as a BGP route reflector and set the cluster ID to 5.5.5.5. For more information, refer
f.
to Section 13.8.11.2, "Configuring the Device as a Route
g. Define an IPv4 address family for VRF1 with the following neighbors:
• Neighbor 1.1.1.1
Parameter
Neighbor IP Address
Autonomous System ID
Route Reflector Client
• Neighbor 1.1.2.2
Parameter
Neighbor IP Address
Autonomous System ID
Route Reflector Client
For more information, refer to
h. Define a redistribution metric for IPv4 family of type connected. For more information, refer to
Section 13.11.11.2, "Adding a
Configure R1
2.
a. Enable BGP and configure the following parameters:
Parameter
Autonomous System ID
Router ID
For more information, refer to
b. Define the following BGP neighbor:
Parameter
Neighbor IP Address
Autonomous System ID
For more information, refer to
c. Define a redistribution metric for BGP of type connected. For more information, refer to
Section 13.8.10.2, "Adding a Redistribution
3. Configure R2
a. Enable BGP and configure the following parameters:
Parameter
Autonomous System ID
Router ID
For more information, refer to
b. Define the following BGP neighbors:
514
Value
1.1.1.1
100
Enabled
Value
1.1.2.2
100
Enabled
Section 13.11.10.2, "Adding an IPv4 Address
Redistribution".
Value
100
5.5.5.1
Section 13.8.1, "Configuring
Value
1.1.1.2
100
Section 13.8.6.2, "Adding a
Metric".
Value
100
5.5.5.2
Section 13.8.1, "Configuring
Reflector".
Family".
BGP".
Neighbor".
BGP".
Example: Route Reflection in a VRF Instance
RUGGEDCOM ROX II
CLI User Guide