Siemens RUGGEDCOM ROX II User Manual page 766

Chapter 16
Traffic Control and Classification
Section 16.4.2
Configuring NetFlow Data Export
To configure the device to send flows to a NetFlow collector, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
IMPORTANT!
NetFlow does not support Layer 3 switching functions. Layer 3 switching must be disabled before
NetFlow is enabled.
2. Make sure Layer 3 switching is disabled by setting the following parameters under switch » layer3-switching
to disabled:
• unicast-mode
• multicast-mode
For more information, refer to
3. Enable the NetFlow service. For more information, refer to
4. [Optional] Set the engine ID that is assigned to each flow record. For more information, refer to
Section 16.4.4, "Setting the NetFlow Engine
5. [Optional] Set the maximum number of active flows tracked by the device. This can help improve
performance in some scenarios. For more information, refer to
Cache".
6. [Optional] Control how RUGGEDCOM ROX II manages active and inactive flows. For more information, refer
to Section 16.4.6, "Controlling Active/Inactive
7. Define one or more interfaces from which to monitor traffic. For more information, refer to
"Adding a NetFlow
8. Define one or more NetFlow collectors to which RUGGEDCOM ROX II can send flows. For more information,
refer to Section 16.4.8.2, "Adding a NetFlow
Section 16.4.3
Enabling/Disabling NetFlow
To enable or disable NetFlow, do the following:
1. Make sure the CLI is in Configuration mode.
2. Enable or disable NetFlow by typing:
Enabling NetFlow
services netflow enabled
Disabling NetFlow
no services netflow enabled
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
720
Section 9.2, "Configuring Layer 3
Interface".
Switching".
Section 16.4.3, "Enabling/Disabling
ID".
Section 16.4.5, "Controlling the NetFlow
Flows".
Collector".
RUGGEDCOM ROX II
CLI User Guide
NetFlow".
Section 16.4.7.2,
Configuring NetFlow Data Export