Siemens RUGGEDCOM ROX II User Manual page 225

RUGGEDCOM ROX II
CLI User Guide
Section 6.8.6.4
Deleting a Public Key
To delete an unsigned public key, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the public key by typing:
no security crypto public-key name
Where name is the name of the public key
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 6.8.7
Managing Certificates
This section describes how to manage certificates on the device.
CONTENTS
• Section 6.8.7.1, "Viewing a List of Certificates"
• Section 6.8.7.2, "Viewing the Status of a Certificate"
• Section 6.8.7.3, "Adding a Certificate"
• Section 6.8.7.4, "Deleting a Certificate"
Section 6.8.7.1
Viewing a List of Certificates
To view a list of certificates, type:
show running-config security crypto certificate
If certificates have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config security crypto certificate
security
crypto
certificate cert
contents
private-key-name key
ca-name
!
!
!
If no certificates have been configured, add certificates as needed. For more information, refer to
"Adding a Certificate".
Deleting a Public Key
"{--contents--}"
ca-cert
Chapter 6
Security
Section 6.8.7.3,
179