Siemens RUGGEDCOM ROX II User Manual page 581

RUGGEDCOM ROX II
CLI User Guide
!
!
If no route filters have been configured, add filters as needed. For more information, refer to
"Adding an Incoming Route
Section 13.9.7.2
Adding an Incoming Route Filter
To add a route filter for incoming advertised routes, do the following:
1. Make sure the CLI is in Configuration mode.
2. Make sure a route map has been configured. For more information, refer to
Maps".
3. Create the new incoming route filter by typing:
• For Standard OSPF Routes
routing ospf incoming-route-filter route-map
• For VRF Routes via OSPF
routing ospf vrf vrf incoming-route-filter route-map
Where:
• vrf is the name of the chosen VRF
• route-map is the name of the route map
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 13.9.7.3
Deleting an Incoming Route Filter
To delete a route filter configured for incoming advertised routes, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the address by typing:
• For Standard OSPF Routes
no routing ospf incoming-route-filter route-map
• For VRF Routes via OSPF
no routing ospf vrf vrf incoming-route-filter route-map
Where:
• vrf is the name of the chosen VRF
• route-map is the name of the route map
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Adding an Incoming Route Filter
Filter".
Unicast and Multicast Routing
Section 13.9.7.2,
Section 13.9.6, "Managing Route
Chapter 13
535