Table of Contents
Advertisement
RUGGEDCOM ROX II
CLI User Guide
Parameter
router-id { router-id }
3.
Configure autonomous system path filters. For more information, refer to
Autonomous System Path
4.
Configure prefix list filters. For more information, refer to
5.
Configure route map filters. For more information, refer to
6.
Configure a network. For more information, refer to
7.
Configure IP addresses for neighbors. For more information, refer to
8.
Configure aggregate addresses. For more information, refer to
Address".
9.
Configure redistribution metrics. For more information, refer to
Metric".
10. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
NOTE
Following a change in the routing policy due to a configuration change, the BGP session must be
reset for the new policy to take effect.
11. Reset the BGP session. For more information, refer to
Section 13.8.2
Managing Route Maps
Route maps are sequential statements used to filter routes that meet the defined criteria. If a route meets the
criteria of the applied route map, it can either be excluded from the routing table or prevented from being
redistributed.
Each route map requires a sequence number (e.g. 10, 20, 30, etc.), which allows for multiple route maps to be
run in sequence until a match is found. It is recommended to create sequence numbers in intervals of 10, in case a
new route map is required later between two existing route maps.
CONTENTS
•
Section 13.8.2.1, "Viewing a List of Route Map Filters"
•
Section 13.8.2.2, "Viewing a List of Route Map Filter Entries"
•
Section 13.8.2.3, "Adding a Route Map Filter"
•
Section 13.8.2.4, "Adding a Route Map Filter Entry"
•
Section 13.8.2.5, "Deleting a Route Map Filter"
•
Section 13.8.2.6, "Deleting a Route Map Filter Entry"
•
Section 13.8.2.7, "Configuring Match Rules"
•
Section 13.8.2.8, "Configuring a Set"
Managing Route Maps
Synopsis: A string 7 to 15 characters long
Router ID for BGP.
Filter".
Description
Section 13.8.5.3, "Adding an
Section 13.8.4.3, "Adding a Prefix
Section 13.8.2.3, "Adding a Route Map
Section 13.8.7.2, "Adding a
Section 13.8.6.2, "Adding a
Section 13.8.8.2, "Adding an Aggregate
Section 13.8.10.2, "Adding a Redistribution
Section 13.8.13, "Resetting a BGP
Chapter 13
Unicast and Multicast Routing
List".
Filter".
Network".
Neighbor".
Session".
481
Hide quick links:
Advertisement
Chapters
Table of Contents
