Siemens RUGGEDCOM ROX II User Manual page 511

RUGGEDCOM ROX II
CLI User Guide
Section 13.7.3.2
Viewing a List of Prefix Entries
To view a list of entries for dynamic RIP prefix lists, type:
show running-config routing rip filter prefix-list name entry
Where:
• name is the name of the prefix list
If entries have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing rip filter prefix-list test entry | tab
SEQ ACTION SUBNET
---------------------------------------------
5 permit 192.168.40.0/24
6 deny 192.168.5.21/32
!
!
If no entries have been configured, add entries as needed. For more information, refer to
"Adding a Prefix Entry".
Section 13.7.3.3
Adding a Prefix List
To add a prefix list for dynamic RIP routes, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the list by typing:
routing rip filter prefix-list name
Where:
• name is the name of the prefix list
3. Configure the following parameter(s) as required:
Parameter
description { description }
4. Add prefix entries as needed. For more information, refer to
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
Section 13.7.3.4
Adding a Prefix Entry
To add an entry for a dynamic RIP prefix list, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the entry by typing:
Viewing a List of Prefix Entries
LE GE
32 -
- -
Synopsis: A string 1 to 1024 characters long
The description of the prefix list.
Unicast and Multicast Routing
Description
Section 13.7.3.4, "Adding a Prefix
Chapter 13
Section 13.7.3.4,
Entry".
465