Siemens RUGGEDCOM ROX II User Manual page 749

RUGGEDCOM ROX II
CLI User Guide
Parameter
protocol { protocol }
destination-ports { destination-ports }
source-ports { source-ports }
test { test }
length { length }
tos { tos }
description { description }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 16.2.6.3
Configuring QoS Marking
Quality of Service (QoS) marking applies a mark to important data packets that should receive preferential
treatment as they travel through the network. Only one QoS mark is allowed for each traffic control rule. Options
include:
• Set: Determines whether the packet or the connection is assigned the QoS mark.
• Modify: Changes the QoS mark value using an AND or OR argument.
• Save/Restore: Replaces the connection's QoS mark value with an assigned value.
• Continue: If the packet matches, no more traffic control rules are checked and the packet is automatically
forwarded to the specified chain.
• DSCP Marking: Determines whether the packet is assigned the DSCP mark.
To configure the QoS mark for a traffic control rule, do the following:
Configuring QoS Marking
This parameter is mandatory.
Synopsis: { tcp, udp, icmp, all } or a string
Default: all
The protocol to match.
Synopsis: A string
(Optional) A comma-separated list of port names, port numbers or port ranges.
Synopsis: A string
(Optional) A comma- separated list of port names, port numbers or port ranges.
Synopsis: A string
(Optional) Defines a test on the existing packet or connection mark.
The default is a packet mark. For testing a connection mark, add ':C' at the end of the test
value. Ex.:
Test if the packet mark is not zero:
!0
Test if the connection mark is not zero:
!0:C
Synopsis: A string
(Optional) Matches the length of a packet against a specific value or range of values...
Greater than and lesser than, as well as ranges are supported in the form of min:max.
Ex.: Equal to 64 64 Greater or equal to 65 65: Lesser or equal to 65 :65 In-between 64
and 768 64:768
Synopsis: { minimize-delay, maximize-throughput, maximize-reliability, minimize-cost,
normal-service } or a string
(Optional) Type of Service . A pre-defined ToS value or a numerical value. The numerical
value is hexadecimal. Ex.: 0x38
Synopsis: A string
A description for this configuration item.
Traffic Control and Classification
Description
Chapter 16
703