Siemens RUGGEDCOM ROX II User Manual page 757

RUGGEDCOM ROX II
CLI User Guide
!
!
!
If no egress marks have been configured, add egress marks as needed. For more information, refer to
Section 16.2.8.2, "Adding an Egress
Section 16.2.8.2
Adding an Egress Mark
To add an egress mark for a QoS Map, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the QoS map by typing:
• For Switched Ethernet Ports
switch vlans all-vlans id qosmap priority egress mark
Where:
▫ id is the ID given to the VLAN
▫ priority is the priority assigned to the QoS map
▫ mark is the value of the egress mark
• For Routable-Only Ethernet Ports
interface eth slot port vlan id qosmap priority egress mark
Where:
▫ slot is the name of the module location
▫ port is the port number (or a list of ports, if aggregated in a port trunk) for the module
▫ id is the ID given to the VLAN
▫ priority is the priority assigned to the QoS map
▫ mark is the value of the egress mark
• For Virtual Switches
interface virtualswitch id vlan vlan-id qosmap priority egress mark
Where:
▫ slot is the name of the module location
▫ port is the port number (or a list of ports, if aggregated in a port trunk) for the module
▫ id is the ID given to the VLAN
▫ priority is the priority assigned to the QoS map
▫ mark is the value of the egress mark
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 16.2.8.3
Deleting an Egress Mark
To delete an egress mark for a QoS map, do the following:
Adding an Egress Mark
Mark".
Chapter 16
Traffic Control and Classification
711