Siemens RUGGEDCOM ROX II User Manual page 644

Chapter 13
Unicast and Multicast Routing
2. Delete the chosen RP address by typing:
no routing multicast dynamic pim-sm rp-address static-address
Where static-address is the Static RP (Rendezvous Point) address
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 13.14.9
Managing Multicast Group Prefixes
When nominated to a Rendezvous Point (RP), the device can serve up to 20 groups of multicast devices. The
device is associated with a multicast group by defining the prefix for the group's multicast IP address (e.g.
225.1.2.0/24).
CONTENTS
• Section 13.14.9.1, "Viewing a List of Multicast Group Prefixes"
• Section 13.14.9.2, "Adding a Multicast Group Prefix"
• Section 13.14.9.3, "Deleting a Multicast Group Prefix"
Section 13.14.9.1
Viewing a List of Multicast Group Prefixes
To view a list of multicast group prefixes, type:
show running-config routing multicast dynamic pim-sm group-prefix
If prefixes have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing multicast dynamic pim-sm group-prefix
routing multicast dynamic pim-sm
group-prefix 225.1.2.0/24
!
!
If no prefixes have been configured, add prefixes as needed. For more information, refer to
"Adding a Multicast Group
Section 13.14.9.2
Adding a Multicast Group Prefix
To add a multicast group prefix, do the following:
NOTE
A maximum of 20 group prefixes can be defined for PIM-SM.
1. Make sure the CLI is in Configuration mode.
2. Add the multicast group prefix by typing:
routing multicast dynamic pim-sm group-prefix prefix
598
Prefix".
RUGGEDCOM ROX II
CLI User Guide
Section 13.14.9.2,
Managing Multicast Group Prefixes