Siemens RUGGEDCOM ROX II User Manual page 541

RUGGEDCOM ROX II
CLI User Guide
3. [Optional] Enable the neighbor as a route reflector client by configuring the following parameter:
Parameter
enabled
4. [Optional] Configure the route map settings by configuring the following parameter(s):
Parameter
in { in }
out { out }
5. [Optional] Configure the neighbor settings by configuring the following parameter(s):
Parameter
remote-as { remote-as }
ebgp-multihop { ebgp-multihop }
maximum-prefix { maximum-prefix }
next-hop-self
password { password }
update-source { update-source }
disable-connected-check
soft-reconfiguration
weight { weight }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
6.
Section 13.8.6.3
Configuring the Distribution of Prefix Lists
To configure the distribution of prefix lists for a neighbor in a BGP network, do the following:
1. Make sure the CLI is in Configuration mode.
2. Apply the desired prefix list the chosen route direction (incoming or outbound) by typing:
routing bgp neighbor address distribute-prefix-list [ in | out ] prefix-list prefix
Configuring the Distribution of Prefix Lists
If enabled and Route Reflector enabled, makes this neighbor a client for Route Reflector.
Synopsis: A string
Apply route map to incoming routes.
Synopsis: A string
Apply route map to outbound routes.
Synopsis: A 32-bit unsigned integer between 1 and 65535
A BGP neighbor.
This parameter is mandatory.
Synopsis: An 8-bit unsigned integer between 1 and 255
The maximum hop count. This allows EBGP neighbors not on directly connected
networks.
Synopsis: A 32-bit unsigned integer between 1 and 4294967295
The maximum prefix number accepted from this peer.
Disables the next hop calculation for this neighbor.
Synopsis: A string 1 to 1024 characters long
Password.
Synopsis: A string 7 to 15 characters long
Source IP address of routing updates.
Disables connection verification when establishing an eBGP peering session with a
single-hop peer that uses a loopback interface.
Per neighbor soft reconfiguration.
Synopsis: A 16-bit unsigned integer
The default weight for routes from this neighbor.
Unicast and Multicast Routing
Description
Description
Description
Chapter 13
495