Siemens RUGGEDCOM ROX II User Manual page 504

Chapter 13
Unicast and Multicast Routing
IMPORTANT!
The system identifier must be unique to the network.
CONTENTS
• Section 13.6.11.1, "Viewing a List of NETs"
• Section 13.6.11.2, "Adding a NET"
• Section 13.6.11.3, "Deleting a NET"
Section 13.6.11.1
Viewing a List of NETs
To view a list of areas configured for dynamic IS-IS routes, type:
show running-config routing isis area name net
Where:
• name is the unique name for a routing process that belongs to a specific router.
If NETs have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing isis area Area_1 net | tab
NET TITLE
---------------------------
49.0001.1921.6800.1001.00
!
!
If no NETs have been configured, add NETs as needed. For more information, refer to
NET".
Section 13.6.11.2
Adding a NET
To add a Network Entity Title (NET) for an IS-IS area, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the NET by typing:
routing isis area name net title
Where:
• name is the unique name for a routing process that belongs to a specific router.
• title is the NET for the router, consisting of a two-octet area ID, a three-octet system ID and a one-octet
selector. For example: 0001.1921.6800.1001.00
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
458
RUGGEDCOM ROX II
CLI User Guide
Section 13.6.11.2, "Adding a
Viewing a List of NETs