Siemens RUGGEDCOM ROX II User Manual page 633

RUGGEDCOM ROX II
CLI User Guide
2. Add the gateway address by typing:
routing ipv4 route subnet dev interface
Where:
• subnet is the subnet (network/prefix) of the static route
• interface is the name of the interface for the static route
3. Configure the following parameter(s) as required:
Parameter
distance { distance }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 13.12.7.4
Deleting an Interface for an IPv4 Static Route
To delete an interface for an IPv4 static route, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the gateway address by typing:
no routing ipv4 route subnet dev interface
Where:
• subnet is the subnet (network/prefix) of the static route
• interface is the name of the interface for the static route
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 13.13
Managing Static Multicast Routing
Static multicast routing allows network designers to control the flow of multicast traffic by manually adding static
routes to the routing table.
CONTENTS
• Section 13.13.1, "Enabling/Disabling Static Multicast Routing"
• Section 13.13.2, "Managing Static Multicast Groups"
• Section 13.13.3, "Managing Out-Interfaces"
Section 13.13.1
Enabling/Disabling Static Multicast Routing
To enable or disable static multicast routing, do the following:
Deleting an Interface for an IPv4 Static Route
Synopsis: A 32-bit unsigned integer between 1 and 255
The distance for the static route.
Unicast and Multicast Routing
Description
Chapter 13
587