Siemens RUGGEDCOM ROX II User Manual page 470

Chapter 12
Tunneling and VPNs
Type
Value
For more information about configuring connection ends, refer to
Connection
g. Add subnet 192.168.50.0/24 for the left connection end. For more information, refer to
Section 12.8.10.3, "Adding an Address for a Private
h. Configure the right connection end for the IPsec tunnel with the following public IP address parameters:
Type
Value
For more information about configuring connection ends, refer to
Connection
i. Add subnet 192.168.60.0/24 for the right connection end. For more information, refer to
Section 12.8.10.3, "Adding an Address for a Private
3. Configure Device B:
a. Configure a host name for the device. For more information, refer to
Name".
b. Add a unique pre-shared key and configure the following parameters:
Local Address
Remote Address
For more information, refer to
c. Add an IPsec connection and configure the following parameters:
Startup Operation
Authenticate By
Connection Type
For more information about IPsec connections, refer to
d. Configure an Internet Key Exchange (IKE) algorithm with default values. For more information, refer to
Section 12.8.7.2, "Adding an IKE
e. Configure an Encapsulated Security Payload (ESP) algorithm with default values. For more information,
refer to Section 12.8.8.3, "Adding an ESP
f. Configure the right connection end for the IPsec tunnel with the following public IP address parameters:
Type
424
Parameter
Ends".
Parameter
Ends".
Parameter
Section 12.8.5.2, "Adding a Pre-Shared
Parameter
Algorithm".
Parameter
address
2.2.2.1
Subnet".
address
2.2.2.2
Subnet".
2.2.2.2/30
2.2.2.1/30
start
secret
tunnel
Section 12.8.6.2, "Adding a
Algorithm".
address
Example: Configuring an Encrypted VPN Tunnel
Value
Section 12.8.9, "Configuring the
Value
Section 12.8.9, "Configuring the
Section 5.2, "Configuring the Host
Value
Key".
Value
Connection".
Value
RUGGEDCOM ROX II
CLI User Guide