Siemens RUGGEDCOM ROX II User Manual page 652

Chapter 14
Network Redundancy
Parameter
state
priority
time-change
interface-state
Section 14.1.3
Enabling/Disabling VRRP
To enable or disable VRRP, do the following:
1. Make sure the CLI is in Configuration mode.
2. Enable or disable VRRP by typing:
Enabling VRRP
services vrrp enabled
Disabling VRRP
no services vrrp enabled
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 14.1.4
Managing VRRP Trackers
VRRP trackers monitor the state/condition of a route. When the route is unavailable, VRRP will lower its priority or
transition it to a fault state.
NOTE
The decision to increase or decrease the priority of a route must be done in coordination with any
backup VRRP Routers since the priority decides whether a router becomes a Master or a Backup. For
example, if Router X's priority is 150 and Router Y's priority is 145, Router X's priority must be lowered
by 6 to make it a Backup router.
CONTENTS
• Section 14.1.4.1, "Viewing a List of VRRP Trackers"
• Section 14.1.4.2, "Adding a VRRP Tracker"
606
Synopsis: A string
The VRRP instance state.
This parameter is mandatory.
Synopsis: A string
The VRRP instance priority.
This parameter is mandatory.
Synopsis: A string
The time of change to the current state.
This parameter is mandatory.
Synopsis: A string
The VRRP interface state.
This parameter is mandatory.
Description
Enabling/Disabling VRRP
RUGGEDCOM ROX II
CLI User Guide